[ Pobierz całość w formacie PDF ]
A3U091768961W01
1. Disengage clips A and pins B using a fastener
remover, then remove the liftgate trim.
2. Install in the reverse order of removal.
End Of Sie
A3U0917W007
HEADLINER REMOVAL/INSTALLATION
A3U091768030W01
1. Disconnect the negative battery cable.
2. Turn the seaming welt and weatherstrip over.
3. Remove the A-pillar trims. (See 09 17 10 A-PILLAR TRIM REMOVAL/INSTALLATION.)
4. Remove the B-pillar upper trims. (See 09 17 11 B-PILLAR UPPER TRIM REMOVAL/INSTALLATION.)
5. Remove the C-pillar trims. (See 09 17 11 C-PILLAR TRIM REMOVAL/INSTALLATION.)
6. Remove the interior and map light if not equipped with a sliding sunroof. (See 09 18 20 INTERIOR AND MAP
LIGHT REMOVAL/INSTALLATION.)
7. Remove the map light and interior light if equipped with a sliding sunroof. (See 09 18 22 INTERIOR LIGHT
REMOVAL/INSTALLATION.) (See 09 18 21 MAP LIGHT REMOVAL/INSTALLATION.)
8. Remove the screws then remove the sunvisor and assist handle.
9. Fold tabs A up if equipped with a sliding sunroof.
10. Remove the fasteners.
Z3U0917W002
09 17 16
1712-1U-01G(09-17).fm 17 000 t^ge0ёfe0HSMRBfR
INTERIOR TRIM
11. Remove the headliner diagonally from the
passenger-side front door frame.
X3U917WB5
Caution
" To protect the trim, seaming welt, etc.
"
"
"
from scratches when removing the
headliner from the vehicle, affix
protective tape to the console, shift lever
knob and door frame.
12. Install in the reverse order of removal.
End Of Sie
X3U917WB4
FLOOR COVERING REMOVAL/INSTALLATION
A3U091768670W01
1. Disconnect the negative battery cable.
09 17
2. Remove the front seats. (See 09 13 1 FRONT SEAT REMOVAL/INSTALLATION.)
3. Remove the rear seat cushion. (See 09 13 5 REAR SEAT REMOVAL/INSTALLATION.)
4. Remove the tire house trim. (See 09 17 13 TIRE HOUSE TRIM REMOVAL/INSTALLATION.)
5. Remove the dashboard. (See 09 17 1 DASHBOARD REMOVAL/INSTALLATION.)
6. Remove the front side trim. (See 09 17 13 FRONT SIDE TRIM REMOVAL/INSTALLATION.)
7. Remove the B-pillar lower trim. (See 09 17 10 B-PILLAR LOWER TRIM REMOVAL.) (See 09 17 11 B-
PILLAR LOWER TRIM INSTALLATION.)
8. Remove the lower anchor of the front seat belt installation bolts.
9. Remove the selector cable if equipped with ATX. (See 05 18 3 SELECTOR LEVER REMOVAL/
INSTALLATION.)
10. Remove the interlock cable if equipped with ATX. (See 05 18 3 SELECTOR LEVER REMOVAL/
INSTALLATION.)
11. Remove the rear heat duct.
12. Remove the fasteners and clips A, then remove
the floor covering.
13. Remove the floor covering from the vehicle
through the passenger-side front door.
14. Install in the reverse order of removal.
End Of Sie
X3U917WB6
09 17 17
[ Pobierz całość w formacie PDF ]